Kansas
Heat Pump Water Heater Cost in Kansas
Estimate the installed cost, applicable rebates, and operating-cost change for a heat pump in Kansas. Calibrated to local labor rates (0.92× HVAC multiplier), retail electricity (14.4¢/kWh), and standard climate.
Estimated installed cost
$3,300
Typical range $2,050 – $6,025 · 240V hybrid HPWH (50 gal)
Low
$2,050
Best case
Mid
Typical$3,300
Typical
High
$6,025
Worst case
Itemized cost breakdown
Click a row for math & sources| Line item | Low | Mid | High |
|---|---|---|---|
Equipment | $1,500 | $2,000 | $2,800 |
Labor State labor multiplier applied (KS). | $442 | $773 | $1,214 |
Permit & inspection | $75 | $175 | $350 |
Job complexity adjustment Reflects installation difficulty, home type, and timing. | $0 | $147 | $1,410 |
Removal & disposal of old equipment | $140 | $200 | $260 |
| Total | $2,050 | $3,300 | $6,025 |
Monthly energy impact
Savings−$4/ mo
Likely savings between $1 and $6 per month vs. your current fuel.
Simple payback (mid)
69 years
Net cost ÷ annual savings vs. current fuel.
Panel upgrade likelihood
Low risk100A typically supports HPWH addition
- Is a 120V plug-in or 240V hybrid model being quoted?
- Is condensate drain work included (drain pan, pump, or gravity routing)?
- Is the install location large enough for proper airflow (typically ≥700 cu ft)?
- Is sound rating (dB) acceptable for the location?
- Is old water heater removal and disposal included?
- Which rebates require pre-approval, and have they been applied for?
- Is the 240V circuit, outlet, or breaker work included if needed?
- Are permits and inspection included?
- Will the cold-air output affect any nearby living space?
- What is the warranty on tank, compressor, and labor?
What can change this price
- Estimates are planning ranges, not contractor quotes. Actual prices depend on your home, local labor rates, equipment, code requirements, utility rules, and contractor availability.
- DOE Energy Saver — Heat Pump Water Heaters— U.S. Department of Energy, reviewed 2026-05-01
- EIA Electricity Retail Sales (state-level)— U.S. Energy Information Administration, reviewed 2026-04-01
- BLS OEWS — Electricians (47-2111)— U.S. Bureau of Labor Statistics, reviewed 2026-05-01
Heat pump rebates & credits in Kansas
| Program | Type | Amount | Expires |
|---|---|---|---|
| Federal · Credit | 30% up to $2,000 | 2025-12-31 | |
| Income-qualified | Federal · Rebate | $0–$1,750 | 2031-09-30 |
Frequently asked questions
How much does a heat pump water heater cost installed?
A 50-gallon 240V hybrid HPWH typically runs $2,200 to $4,200 installed nationally. A 120V plug-in unit runs $1,700 to $3,400. State labor rates and the cost of a new 240V circuit shift the band. Use the calculator above for a state-calibrated estimate.
What rebates apply to HPWHs?
The federal 25C credit expired Dec 31 2025 (OBBBA). DOE HEEHRA provides up to $1,750 for HPWHs in income-qualified households where the state has launched the program. State and utility programs vary; the rebate table above shows what applies in your state.
Where should an HPWH be installed?
HPWHs need about 700 cubic feet of free air space to maintain rated efficiency. A conditioned basement or utility room works well; an unconditioned garage is fine in moderate climates but risky where ambient drops below the unit cutoff temperature.
HPWH cost by state
- Alabama
- Alaska
- Arizona
- Arkansas
- California
- Colorado
- Connecticut
- Delaware
- Florida
- Georgia
- Hawaii
- Idaho
- Illinois
- Indiana
- Iowa
- Kansas
- Kentucky
- Louisiana
- Maine
- Maryland
- Massachusetts
- Michigan
- Minnesota
- Mississippi
- Missouri
- Montana
- Nebraska
- Nevada
- New Hampshire
- New Jersey
- New Mexico
- New York
- North Carolina
- North Dakota
- Ohio
- Oklahoma
- Oregon
- Pennsylvania
- Rhode Island
- South Carolina
- South Dakota
- Tennessee
- Texas
- Utah
- Vermont
- Virginia
- Washington
- West Virginia
- Wisconsin
- Wyoming
- District of Columbia